Build gallery

My builds

These are real drones I assembled and shipped, with different TPU prints, on the workbench and out in the field. I flew each one before it went to its owner. The gallery also includes close-ups of the assembly and TPU prints straight from the workshop.

FPV drone with orange guards and purple props on a dashboard — Ikon 2.8 - rocket build with O4 Wide

Close-up of the electronics and a motor on an FPV drone — Drone electronics - a close-up of the assembly

Red and black power wires soldered to a board — Soldering - a close-up of the power connections

Red prints laid out on a workbench — TPU prints - parts on the workbench

Packaged red prints labelled Ikon 2.8 and Nexa — TPU kits - prints for the Ikon 2.8 and Nexa

Build with orange TPU prints on a workbench mat — Nexa 3.5 - orange TPU prints on the bench before the props go on

Build with red TPU prints and a GNB battery on a workbench mat — Ikon 2.8 - red TPU prints

Build with green TPU prints — Nexa 3.5 and Ikon 2.8 - two builds from the same batch, with green and orange prints

Build with red TPU prints on a desk — Nexa 2.8 - red prints, assembled and ready to tune

Build with blue TPU prints on a workbench mat — Nexa 3.5 - 1605 AOS motors and blue prints, before fitting the props and camera

Bare frame with motors and electronics installed — Ikon 2.8 - bare frame with the stack and motors fitted, before adding TPU prints

Drone on a kitchen scale — Ikon 2.8 - high-KV motors and GPS, weighing 158 g with full O4 Pro and no battery

Drone with a battery on a park bench — Nexa 3.5 - green prints, ready to fly at the park

Close-up of the stack and wiring — Nexa 3.5 - close-up of the stack and wiring, with orange prints

Side view of a drone against a light background — Ikon 2.8 - green prints and high-KV motors

Several drones laid out on a backpack in the field — Four builds - a batch out in the field, ready to ship

Video

From the air

Flight footage and OSD readings

Flight footage

In-flight OSD screenshot showing 191 km/h — OSD screenshot - 191 km/h on the Ikon 2.8 with carefully chosen props

Nexa 3.5 - POS/ALT Hold

OSD after a relaxed flight with the Ikon 2.8 — Ikon 2.8 - a very gentle flight on a Tattu 1100 mAh pack. The OSD shows 9 min 22 s of flight time and 1060 mAh used.

Ikon 2.8 - flight on a Tattu 1000 mAh 160C pack

Want a build like this?

Use the configurator to find a model, motor variant and battery for how and where you fly. It gives you a ready-to-send message at the end.

Build me a drone Compare the builds